Tip Shroud - Stratasys Prodigy Plus User Manual

48 Maintenance
4. Pull on the socket wires while inserting the two prongs of
the new lamp into the two holes of the socket. When the
lamp is seated into the socket, release the socket wires.
5. Plug the socket wires back into the wire harness.
Pulling on the socket wires releases the spring-loaded
contacts in the socket. If the lamp is installed without
pulling on the socket wires, the lamp might not be held
securely in the socket.

Tip Shroud

Due to repeated contact with the tip-wipe brush, it is normal for the
tip shroud to become worn. When chronic build up of material
around the tip area or clumps of burnt material become imbedded
in the part, replace the tip shroud.
1. Enter Maintenance and access the Table Maintenance
function.
The head temperature decreases.
Prodigy Plus User Guide
Do not touch the new bulb with bare
fingers. The natural oil of your skin can
cause premature bulb failure. Grasp the
base of the bulb instead.
Use only 24 V, 20 W bulbs.
Note
Head area is very hot! Use gloves when
installing a new shroud!
WARNING
CAUTION