11.7.8.1 Remove Kapton Tape (2696) from the Muffler Assembly and left strut (9779-SEQ), as shown in figure.
Cut cable
tie here
11.7.8.2 Remove exhaust tube and ATF to product tank tubing. Cap the connection port on the ATF that is exposed when the
tubing is removed.
Exhaust
Tube
11.7.8.3 Cut and remove 2 Cable Ties (6968-SEQ) as shown on
figure below.
NOTE: Leave the cable tie closest to the Compressor/Product Tank
Assembly Intact.
11.7.8.4 Remove the silicone tubing from the ATF, leaving the
tubing attached to the Compressor Assembly.
NOTE: May need to carefully pry tubing from ATF ports with a
tool.
58 | 9735-SEQ H
11.7.8 ATF & COMPRESSOR / TANK ASSEMBLY REMOVAL
Figure 11-33. Kapton Tape
Figure 11-34. Exhaust tube
Operator & Service Manual
Muffler Assy
2x3" tape
Figure 11-35. Cable Ties
Figure 11-36. Silicone tubing