Table 5-4. Utility Menu Screens - Saros 9400R-SEQ Operators & Service Manual

Operator & Service Manual
NOTE: Pressing and holding the Utility button for at least 10 seconds will reset the SAROS. To restart, press and hold ON/OFF (Standby)
button.
The following sequence of screens shall be displayed on the LCD when the Utility Menu is displayed.
Format: AC=XXXX
Alarm Codes
See Alarm Code Table definitions. When more than one alarm code is present, pressing the Increase key will
show the next highest priority code and pressing the Decrease key will show the next lowest priority code.
Pulse Sensitivity Format: P SENS = X (where X is the value of 1 thru 3)
LCD Contrast Format: LCD CT = X (where X is the value from 1 thru 6)
Format N BRT = X (where X is 1 thru 6)
Normal Mode
Brightness
Selects the LED and LCD backlight Light intensity used in Normal Mode.
Format T BRT= X (where X is 0 thru 6)
Tactical Mode
Brightness
Selects the LED and LCD backlight Light intensity used in Tactical Mode.
Tactical Buzzer Volume Format: T VOL=X (where X is the value from 0 thru 6)
Format: TACT=ON
Tactical Mode On / Off
selection
Format: TACT=OFF
Format: 9V = GOOD
9V Battery Status
Format: 9V = RPLC
Hours of Operation Format: HR= XXXXX
System Software Part Format: SPPPP Mm
Number and Revision (where SPPPP = System Software Part Number, M = Major Version, and m = minor Version)
Motor Software Part Format: MPPPP Mm
Number and Revision (where MPPPP = Motor Software Part Number, M = Major Version, and m = minor Version)
Step 7: Begin using the SAROS
NOTE: You will achieve longer operating time on the Battery if you operate in the Pulse Flow Mode.
Step 8: Power off the Device
Press and hold the "ON/OFF" Standby Button for two (2) seconds to power OFF the SAROS.

Table 5-4. Utility Menu Screens

9735-SEQ H | 31