Operator & Service Manual
11.8.9 MEMBRANE PANEL REPLACEMENT (9731-SEQ)
11.8.9.1 After performing steps 11.7.1.1 thru 11.7.1.8 from "INLET CAP REMOVAL".
11.8.9.2 Peel off the User Panel (9731-SEQ) as shown in the
figure below.
Figure 11-73. Peel
11.8.9.3. Clean the surface shown in the figure below with Iso-
clean
propyl Alcohol before re-applying the new User Panel.
surface
Figure 11-74. Clean
11.8.9.4 Remove the PSA protective cover from the new User
Panel (9731-SEQ). Insert the Flex Cable as shown in the figure
below.
Figure 11-75. Remove PSA cover
11.8.9.5 Position and apply the new User Panel as shown in the
figures below. Press firmly on the entire surface of the new User
Panel to insure that it is bonded correctly.
Figure 11-76. Apply new User Panel
11.8.9.6 Reconnect the small tube (4056-SEQ [2.3"]).
11.8.9.7 Perform steps 11.8.10.4 - 11.8.10.11 from section "INLET CAP INSTALLATION".
70 | 9735-SEQ H