11.7.6.1 Pull out the wires from the grommets on the bulkhead
of the Compressor as shown in figure below.
11.7.6.2 Remove the two large wires (Battery Connector Cable)
thru the middle Bulkhead as shown in figure below.
11.7.6.3 Remove the Wire Sleeve with the wires thru the Bulk-
head.
11.7.6.4 Cut and remove the 6 Cable Ties (part# 6968-SEQ) on the Side Rail & Cable Ties that group the Cable bundle togeth-
er.
CAUTION: Do not cut wires.
56 | 9735-SEQ H
11.7.6 BATTERY CABLE REMOVAL (9201-SEQ)
Hall Effect
Sensor
Hall Effect
Sensor
ATF power & ATF
thermistor wire
connector cable
Battery Connector
Cable (9201-SEQ)
Figure 11-29. Cable Ties and Rails
Operator & Service Manual
Figure 11-27. Hall Effect Sensor
Figure 11-28. Remove Wire Sleeve
3" wire sleeve
(9638-SEQ)