Figure 5-1. Battery Installation; Table 5-2. Minimum Remaining Time On Battery - Saros 9400R-SEQ Operators & Service Manual

Table of Contents

Power the SAROS ON, with the AC Power Adapter plugged in, and the Battery correctly installed. With the device powered ON,

allow the Battery to completely charge. The Battery is fully charged when the Battery Status Gauge Indicator on the Control Panel

is completely illuminated or the device has been charging for a minimum of 5 hours.

CAUTION: Do not leave the SAROS, or battery, in the seating area of a motor vehicle or in the trunk of a motor

vehicle during a hot day.

NOTE: The SAROS can be used when either discharging or recharging of the Battery is taking place.

NOTE: The storage temperature range for the device is -4° F (-20° C) to +140° F (+60° C) and 95% non-condensing humidity.

In the event of an external power interruption, the SAROS will automatically switch to the Battery operation. When external

power is restored, the Battery will automatically start recharging. If the Battery is not present, or fully discharged, during an exter-

nal power interruption, the SAROS will shut down.

LOW BATTERY ALERTS

The table below describes the LCD Display and Alarm for Low Battery Conditions.

MINIMUM REMAINING TIME ON BATTERY

Time Remaining (Min)

Battery Icon

Alarm

NOTE: Momentarily press the Utility Button to silence the Loss of Power alarm for 2 minutes. Connecting the SAROS to an external AC

power supply will also eliminate this alarm.

When replacing the Battery without the device being externally powered, push the ON/OFF (Standby) to restart the SAROS.

BATTERY INSTALLATION ONTO SAROS

1. Remove connector and pin caps.

2. Press the Latching Pin Release Button inward on the bottom of the Battery prior to installing onto the SAROS.

NOTE: It is important to depress the latching pin release button prior to installation.

3. Insert the Battery onto the SAROS by aligning the Battery Connector of the Battery into the connector opening at the bottom of

the unit. Battery is properly engaged when the latch pin is snapped into place.

28 | 9735-SEQ H

< 6 Minutes

7 Minutes < X < 15 Minutes

Flash

Solid

OFF

Table 5-2. Minimum Remaining Time on Battery

Latching Pin

Release

Button