Preparation For Use And Installation; Battery Installation Onto Saros; Locating The Saros; Saros Performance Verification Test - Saros 9400R-SEQ Operators & Service Manual

Operator & Service Manual

3.0 PREPARATION FOR USE AND INSTALLATION

Pre-Delivery Check List
Before delivering the device, check and log the status of the following:
Parts Inventory – Verify that each SAROS is provided with the following items:
• SAROS Concentrator
• AC Power Cord
• AC Power Adapter
• 24 VDC Cable
• Battery
• Nasal Cannulas (2)
• Operator and Service Manual
• Spare Filter Set

3.1 BATTERY INSTALLATION ONTO SAROS

1. Remove connector and pin caps.
2. Press the Latching Pin Release Button inward on the bottom of the Battery prior to installing onto the SAROS.
NOTE: It is important to depress the latching pin release button prior to installation.
3. Insert the Battery onto the SAROS by aligning the Battery Connector of the Battery into the connector opening at the bottom of
the unit. Battery is properly engaged when the latch pin is snapped into place.
Battery
Connector
Latching Pin
Release
Button
Battery Connector of
SAROS

Figure 3-1. Battery Installation

3.2 LOCATING THE SAROS

Place the SAROS in a well-ventilated area. Be sure the air inlet and exhaust vent are not obstructed.
Position the SAROS so all audible and visual indicators or alarms can be easily seen and heard.
Connect the AC Power Adapter to External Power Receptacle located on top of the device and plug the device into a grounded AC
Power outlet, connect to a DC Power source with the 24 VDC Cable, or be sure there is a fully charged Battery installed.

3.3 SAROS PERFORMANCE VERIFICATION TEST

It is recommended that the SAROS performance verification test be preformed upon initial receipt of the device to confirm proper
operation before the unit is distributed or used in the field. The full procedure is listed in section 6.6 on page 35–37.
20 | 9735-SEQ H