Table of Contents
Advertisement
Operator & Service Manual
11.8.10.10 Insert and connect the 9V Battery (9257-SEQ) and
the Filter (9798-SEQ).
11.8.10.11. Align the Air Inlet Cover (9758-SEQ) to the top of
the SAROS and tighten the four screws (P9291-SEQ).
11.8.11 INSTALLATION OF THE SLEEVE & BATTERY INTERFACE PLATE
11.8.11.1 Slide Sleeve (9280-SEQ) and Ring sleeve with O-
Rings (9928-SEQ) over struts, and insert it into Aligning Ring
that is attached to the Inlet Cap.
11.8.11.2 Align second Sleeve (9928-SEQ) AND O-RING
(9928-SEQ) over the STRUTS, to the Sleeve leaving the Battery
board exposed.
filter
Figure 11-85. 9V battery
tighten
screws
Figure 11-86. Align covers and tighten
Figure 11-87. Slide Sleeves
Figure 11-88. Second sleeve
sleeve
alignment
ring
9735-SEQ H | 73
- Quick Links:
- General Information
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
