Atf & Compressor/Product Tank Installation; Figure 11-41. Atf Bulkhead; Figure 11-42. Align; Figure 11-43. Atf Caps - Saros 9400R-SEQ Operators & Service Manual

NOTE: A flow calibration procedure is required after replacing the ATF or Compressor, the PCB Circuit Board, the Proportional Valve. If
any of these components are replaced, the SAROS must be returned to CAIRE or a factory-authorized service center to have the flow
calibration performed before returning to use.
11.8.2.1 Install the ATF Bulkhead Assembly onto the bottom of
ATF Module Assembly as shown in figures below.
11.8.2.2 Place the ATF Assembly and Compressor Assembly
next to each other and align as shown in figure below.
11.8.2.3 Remove Caps (3575-SEQ) from the ATF. Insert the
Ports from the ATF into the tubes on the Compressor /Tank As-
sembly. Press the ATF & Compressor together and ensure that
the hoses are positioned properly.
NOTE: Pre-wet inner tubing on compressor with alcohol. Also, wet
metal barbs on the ATF.
NOTE: Use Isopropyl Alcohol to lubricate the Tube and the Barb
and use a Mechanics Grabber Pliers to attach the down pipe hose
from the Compressor Assembly to the fitting on the ATF Module
Assembly.
60 | 9735-SEQ H
11.8.2 ATF & COMPRESSOR/PRODUCT TANK INSTALLATION
Grommet
(9739-SEQ)
ATF bulkhead
(9922-SEQ)

Figure 11-41. ATF Bulkhead

ATF module assy
(SP9729-SEQ)
ATF bulkhead
assy (9739-SEQ)

Figure 11-42. Align

Remove caps

Figure 11-43. ATF caps

pliers

Figure 11-44. Down pipe Hose

Operator & Service Manual