Ram To Rom Via The Canopen Object 1010 - Siemens SINAMICS G110M Function Manual

6.5

RAM to ROM via the CANopen object 1010

Save the parameters of the inverter EEPROM using CANopen object 1010.
The following options are available:
● 1010.1: Save all parameters - identical with p0971 = 1, or back them up so they are not
lost if the power fails.
● 1010.2: Save communication parameters - not possible via parameter settings!
● 1010.3: Save application parameters - not possible via parameter settings!
If a memory card is inserted, write the parameter settings via the control with object 1010.1
into the EEPROM and to the memory card. You can carry out series commissioning with the
memory card.
For additional information, please refer to the operating instructions, Chapter "Backing up
data and series commissioning"
Note
Save data using objects 1010.2 and 1010.3
Although you can write the communication and/or application parameters to the EEPROM
using objects 1010.2 and 1010.3, you cannot write them to the memory card. This also
means that it is not possible to load the communication data or only the application data from
one inverter into the next via the memory card.
Note
With the USB cable inserted, save the data in the inverter via the control.
If the inverter is connected with a computer via USB but Startdrive cannot access the
inverter online, then you cannot save data in the inverter using CANopen object 1010.
Withdraw the USB cable from the inverter if you wish to save the parameter setting with
object 1010.1 in the inverter via the control.
Fieldbuses
Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
Overview of the manuals (Page 232),
Communication over CANopen
6.5 RAM to ROM via the CANopen object 1010
193