Diagnostics With Profinet - Siemens SINAMICS G110M Function Manual

Communication via PROFIBUS and PROFINET
3.3 PROFIdrive profile - Diagnostic channels
3.3.1

Diagnostics with PROFINET

PROFINET uses the channel diagnostics to transfer PROFIdrive message classes.
9000 hex Hardware/software error
9001 hex Network fault
9002 hex Supply voltage fault
9003 hex DC link overvoltage
9004 hex Power electronics faulted
9005 hex Overtemperature of the electronic components
9006 hex Ground fault / inter-phase short circuit
9007 hex Motor overload
9008 hex Communication error to the higher-level control
system
9009 hex Safety monitoring channel has identified an
error
Figure 3-18 Structure of the channel diagnostics
48
900A hex Position/speed actual value incorrect or not
available
900B hex Internal (DRIVE-CLiQ) communication error
900C hex Infeed faulted
900D hex Braking module faulted
900E hex Line filter faulted
900F hex External measured value / signal state outside
the permissible range
9010 hex Application / technological function faulted
9011 hex Error in the parameterization / configuration
/commissioning procedure
9012 hex General drive fault
9013 hex Auxiliary unit faulted
Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
Fieldbuses