Siemens SINAMICS G110M Function Manual page 157

Instance Object name
ID
BV8 AT SET-
POINT
BV9 AT MAX
FREQ
BV10 DRIVE
READY
BV15 RUN COM
ACT
BV16 HIB MOD
ACT
BV17 ESM MOD
BV20 RUN / STOP
CMD
BV21 FWD / REV
CMD
BV22 FAULT
RESET
BV24 CDS
BV26 RUN ENA
CMD
BV27 OFF2
BV28 OFF3
BV50 ENABLE PID Enable technology controller
BV51 ENABLE PID
0
BV52 ENABLE PID
1
BV53 ENABLE PID
2
BV90 LOCAL
LOCK
BV93 CTL
OVERRIDE
CMD
Fieldbuses
Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
5.5 Communication via BACnet MS/TP - only CU230P-2 HVAC / BT
Description
Setpoint reached
Maximum speed reached
Inverter ready
ACT indicates the status of the ON
command, regardless of the source
ACT means that the inverter is
operating in energy-saving mode.
ACT means that the inverter is
operating in the essential service
mode
ON command for the inverter (when
controlling via BACnet)
Reverse direction of rotation (when
controlling via BACnet)
Acknowledge fault (when controlling
via BACnet)
Local / Remote
Enable inverter operation
OFF2 status
OFF3 status
Note:
BV28 sets the r0054.4, r0054.5,
and r0054.6 bits
Enable technology 0 controller
Enable technology 1 controller
Enable technology 2 controller
Use MANUAL (operator panel) to
lock inverter control
Inverter control using BACnet over-
ride control
Possible values Text
active
YES / NO YES
YES / NO YES
YES / NO YES
YES / NO 0
ON/OFF 0
ON/OFF 0
RUN / STOP 0
REV / FWD 0
RESET / NO 0
Local / Remote YES
ENABL
ED
RUN / STOP 0
RUN / STOP 0
ENABLED / ENABL
DISABLED ED
ENABLED / ENABL
DISABLED ED
ENABLED / ENABL
DISABLED ED
ENABLED / ENABL
DISABLED ED
LOCK
ON/OFF 0
Communication via RS485
Text Ac- Parameter
inactive cess
type
NO R r0052.8
NO R r0052.10
NO R r0052.1
1 R r2032[0]
1 R r2399[1]
1 R r3889[0]
1 C r0054.0
1 C r0054.11
1 C r0054.7
NO C r0054.15
DISABL C r0054.3
ED
1 C r0054.1
1 C r0054.2
DISABL C p2200
ED
DISABL C p11000
ED
DISABL C p11100
ED
DISABL C p11200
ED
UNLOC C p0806
K
1 C r0054.10
155