Siemens SINAMICS G110M Function Manual page 213

Table 6- 7
BF
Display of the operating state using the alarm object (Emergency Object)
Error states are displayed using the alarm object (Emergency Object), OV index 1014 in the
emergency telegram. It has the following structure:
Bytes 0 and 1:
•
Byte 2:
•
Byte 5:
•
Errors trigger an emergency telegram and cause the drive to shut down.
You can suppress the emergency telegram by setting bit 31 in object 1014 hex to 1.
This means that shutdown is not suppressed, however the fault message is not sent to the
master.
Fieldbuses
Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
CANopen fieldbus
Explanation
Data exchange between the inverter and control system is active ("Operational" state)
Fieldbus is in the "Pre-operational" state
Fieldbus is in the "Stopped" state
No fieldbus available
RDY When LED RDY flashes simultaneously:
Firmware update failed
Alarm - limit reached
Error event in the higher-level control system (Error Control Event)
Inverter waits until the power supply is switched off and switched on again after a firmware
update
Incorrect memory card or unsuccessful firmware update
Firmware update is active
CANopen error code
Codes for the CANopen error register
Number of the drive object. For G120 inverters, this is always = 1
Communication over CANopen
6.8 Error diagnostics
211