Slide Wall Assembly - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 7: Slide Wall Assembly
A: Place (072) Narrow Panel Back against the left side of (071) Nest End Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(072) Narrow Panel Back to (071) Nest End Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (Fig. 7.1, 7.2 and 7.4)
B: Place (073) Narrow Front Panel against the right side of (071) Nest End Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(071) Nest End Panel to (073) Narrow Front Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (Fig. 7.1, 7.3 and 7.4)
Fig. 7.2
Flush
072
Notice (072) Narrow
Back Panel overlaps
(071) Nest End Panel
Fig. 7.4
WL5
Wood Parts
1 x Nest End Panel 1-1/4 x 37 x 92"
071
1 x Narrow Panel Back 1-1/4 x 21-1/2 x 92"
072
1 x Narrow Front Panel 1-1/4 x 21-1/2 x 92"
073
Fig. 7.1
071
WL5
071
Flush
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
29
Fig. 7.3
073
Notice (071) Nest End
Panel overlaps (073)
Narrow Front Panel
WL5
Flush
071