Swing Wall Assembly - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 8: Swing Wall Assembly
A: Place (082) Panel Front Wall against the left side of (081) SW Wall Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (082)
Panel Front Wall to (081) SW Wall Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 8.1 and 8.2)
B: Place (083) Wall Panel Back against the right side of (081) SW Wall Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(081) SW Wall Panel to (083) Wall Panel Back with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 8.1 and 8.3)
Fig. 8.2
Flush
082
Notice (082) Front Wall
Panel overlaps (081)
SW Wall Panel
Wood Parts
1 x SW Wall Panel 1-1/4 x 37 x 92"
081
1 x Panel Front Wall 1-1/4 x 43 x 92"
082
1 x Wall Panel Back 1-1/4 x 43 x 92"
083
081
Fig. 8.1
WL5
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
30
Fig. 8.3
083
081
Flush
Flush
081
Notice (081) SW Wall
Panel overlaps (083)
Back Wall Panel
WL5