Attach Diagonal - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 14: Attach Diagonal
A: Loosely attach (141) SW Ground to (142) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat washer
and t-nut) then place (142) Diagonal tight and flush to the front of (081) SW Wall Panel. The (141) SW Ground
should be flush to the bottom of (081) SW Wall Panel. (fig. 14.1 and 14.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (142) Diagonal to (081) SW Wall Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 14.1 and 14.2)
C: Make sure bottom of (141) SW Ground is flush to bottom of (081) SW Wall Panel then attach with 2 (S11) #8
x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw. Tighten the (WB9) Wafer Bolt installed in Step A. (fig. 14.1
and 14.2)
Fig. 14.1
Wood Parts
1 x SW Ground 15/16 x 3-1/4 x 14-1/4"
141
1 x Diagonal 1-1/4 x 3 x 22"
142
Fig. 14.2
081
142
5/16"
T-Nut
Hardware
WB9
1 x 5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
38
5/16" Flat
Washer
WL5
141
5/16" Flat
WB9
Washer
Flush
081
S11
S4