Install Joist Assembly - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 10: Install Joist Assembly
A: From inside the assembly measure 5/8" (15.9mm) down from the top of the Wall Panels and place the joist
assembly so that the (042) Front Wall Tie and (043) Back Wall Tie are tight to Wall Panel as shown in fig.10.1.
Loosely attach the assembly using 4 (H10) 1/4 x 2-1/4" Hex Bolts (with lock washer, flat washer and t-nut). (fig.
10.1 and 10.2)
B: Place (101) Nest Center Joist so that it lines up with the remaining set of pre-drilled holes in the (041) Nest
Mid Joist and the center of (071) Nest End Panel and attach using 4 (S3) #8 x 2-1/2" Wood Screws. (fig. 10.3 and
10.4)
C: Make sure that assembly is level and install 4 (S11) #8 x 2" Wood Screws into (042) Front Wall Tie and (043)
Back Wall Tie as shown in fig.10.5. Tighten all bolts. (fig. 10.3 and 10.5)
Fig. 10.1
Hidden
042
Wall Panel
Fig. 10.3
071
101
S3
042
Hidden
Wood Parts
1 x Nest Center Joist 15/16 x 2-3/8 x 12-1/8"
101
install loosely with bolts only, 5/8" down
Fig. 10.2
Wall Panel
043
041
S3
Hardware
4 x #8 x 2-1/2" Wood Screw
S3
4 x #8 x 2" Wood Screw
S11
4 x 1/4 x 2-1/4" Hex Bolt (with 1/4" lock washer,
H10
1/4" flat washer and 1/4" t-nut)
1/4" Lock washer
H10
1/4" flat washer
1/4" t-nut
Fig. 10.4
041
Fig. 10.5
S11
33
install loosely with bolts only, 5/8" down
Install loosely with bolts
only, 5/8" down
1/4" flat washer
H10
1/4" Lock washer
S3
Tighten bolts now as well
5/8"
(15.9mm)