Install Nest Wall Joists - KidKraft Cedar Summit Lookout Extreme Installation And Operating Instructions Manual

Step 38: Install Nest Wall Joists
A: Measure 5/8" (15.9mm) down from the top of the End Wall and place 1 (381) Nest Floor Joist A so that the 2 pre-
drilled holes are on the left side. Before attaching the Nest Joist make sure that it measures 1-7/8" (47.1mm) from the left
edge of the assembly and 1-15/32" (35.5mm) from the right edge. Attach using 6 (S11) #8 x 2" Wood Screws. (fig. 38.1,
38.2 and 38.3)
B: Place (382) Nest Wall Spacer in the opening of the End Wall Panel so that it sits against the floorboards and is
flush with the End Panel. (fig. 38.1 and 38.3)
C: Measure 5/8" (15.9mm) down from the top of (382) Nest Wall Spacer and place 1 (381) Nest Floor Joist A so
that the 2 pre-drilled holes are on the left side, making sure to maintain a measurement of 1-7/8" (47.1mm) from
the left edge of the assembly and 1-15/32" (35.5mm) from the right edge. Attach (381) Nest Floor Joist A and (382)
Nest Wall Spacer using 6 (S11) #8 x 2" Wood Screws. (fig. 38.1, 38.2 and 38.3)
D: From inside the fort center 1 Flat Panel Bracket over the ends of (382) Nest Wall Spacer and (071) Nest End
Panel. Attach each Flat Panel Bracket using 4 (S0) #8 x 7/8" Truss Screws. (fig. 38.4)
Fig. 38.1
Fig. 38.4
Inside View
Wood Parts
2 x Nest Floor Joist A 1-1/2 x 1-1/2 x 35"
381
1 x Nest Wall Spacer 1-1/4 x 4 x 31"
382
Fig. 38.2
Top View
381
381
382
Bracket
382
x 4 per
S0
bracket
12 x
8 x
End Wall
1-7/8"
(47.1mm)
381
Fig. 38.3
S11
Flush
Hardware
#8 x 2" Wood Screw
S11
#8 x 7/8" Truss Screw
S0
78
381
S11
x 6
381 382
Other Parts
2 x Flat Panel Bracket
1-15/32"
(35.5mm)
5/8"
(15.9mm)
5/8"
(15.9mm)
x 6
S11