Printing With Review And Print Keys - Honeywell Vibrex 2000 User Manual

<ALL RUNS>
Printing Optical Blade Tracker (OBT) Debug Log
(EV2K+ Heli Only) -
as the
useful if the FasTrak
It normally should be sent to a qualified representative for
interpretation.
NOTE: The most common reasons for erratic FasTrak
sun angle and worn or unpainted blades. Check the FasTrak
magnetic pick-up connections if the data is completely missing.
CAUTION: Because of limited memory, this debug log is
overwritten for each FasTrak
readings persist after checking the sun angle or blade condition,
then this log should be printed immediately after the affected
run.
3.3.4.2
Using the
readings or sessions for printing. The user may select any of the
following printing categories:
Prop Runs
Spectrum
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
context key is pressed. This debug log is very
PRINT
®
acquisition is erratic or missing track data.

Printing With REVIEW and PRINT Keys

key, the user may review and select specific
REVIEW
Select the propeller measurement, rear
measurement, or adjustment to be printed
and press
RUN>
Select the run to be printed and press
PRINT
press
selects a run to be printed by the
Chapter 3 – Getting Started
Prints all helicopter FasTrak
stored to memory.
The OBT Debug log is printed as soon
®
acquisition. If erratic or missing
. Select
PRINT
and press
START
. Select
<CURRENT MEAS>
or
START PRINT
13841 Rev A
51
®
runs
®
data are
®
and
<CURRENT
or .
PRINT
then
. When the user
REVIEW