Finishing Propeller Balance - Honeywell Vibrex 2000 User Manual

Chapter 5 – General Operation
► SELECT ANOTHER JOB
? IMPORTANT! – Were
these changes made?
► YES, begin next run
5.4.4
The weights outside on the spinner are not a permanent
installation. The user must move the weights to a permanent
location according to the guidelines found in The Smooth
Propeller Manual (Honeywell).
Continue toward a permanent weight installation, for the Vibrex
2000 and Vibrex 2000 Plus as follows:
1. Press the
propeller balance quality screen.
2. If a radius change will occur for the installation of the
permanent weight, press the
key.
NOTE: The radius is the number of inches (or any unit)
from the center of rotation. An easy way to determine the
radius is to measure the diameter of the spinner when it is
removed and divide that number by 2.
3. Enter the trial weight radius, using the numeric keypad.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
ID:
35.00 gms @ 12:00
NO, GO BACK to edit

Finishing Propeller Balance

INSTALL PERMANENTLY
-1
context key from the
CURRENT RADIUS
13841 Rev A
122
context