Powering Up - Honeywell Vibrex 2000 User Manual

5.2.1
To turn on the Vibrex unit, press the
the unit press the
following powering on- and-off features:

To keep the user from powering down the unit
unintentionally, the user must hold down the ON/OFF button
for at least 1 sec. while the unit is in operation.

If there are no key presses or activity on the balancer for 10
min., the unit enters a "rest" mode to keep the batteries fresh.

To restart the unit at any time, press the ON/OFF button
again.
NOTE: All Vibrex 2000 units come shipped with batteries.
If the batteries run low or lose power, the Vibrex unit may
not power up. However, the user does not lose data stored
in the memory during this time. The unit keeps data in its
memory for up to 8 hr. without batteries and/or power.
5.2.2
The Main Menu screen is slightly different for the Vibrex
2000/Vibrex 2000 Plus and the Enhanced Vibrex 2000 Plus.
Vibrex 2000 and Vibrex 2000 Plus
Directly after the Vibrex 2000 or Vibrex 2000 Plus powers up,
the Self- test screen displays (telling the user the unit is testing
itself), then the Main Menu screen. The illustration below shows
the Main menu.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.

Powering Up

button again. The unit has the
ON/OFF
Main Menu Screen
13841 Rev A
89
Chapter 5 – General Operation
button. To turn off
ON/OFF