Honeywell Vibrex 2000 User Manual page 55

pressed and the off-line lamp when the
pressed to allow confirmation of the button operation.
6. After the
lamps alternately blink, and the new settings are written to
memory. When the printer finishes writing everything to
memory, the DIP SW setting complete message is
printed out, and the printer returns to the on-line mode.
7. As soon as switch No. 8 of DIP SW-3 is set, the printer
writes the settings to memory regardless of which button
(
ONLINE
example of the settings printout.
CAUTION: Never turn off the printer while it is writing the
new settings to memory. Always wait until the DIP SW
setting complete message is printed, then turn the
power off.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
button is pushed, the on-line and off-line
FEED
or ) is pushed. See the following page for an
FEED
13841 Rev A
Chapter 3 – Getting Started
FEED
39
button is