Troubleshooting - Honeywell Vibrex 2000 User Manual

3. Orient the main PCB so its attached LCD screen and the
4. Slide the main PCB into the chassis slowly, paying
5. Use fingers to connect the ribbon cable to the keyboard
6. Line up the shield (02) and screw it back in place with
7. Attach the connector end plate (04) to the chassis with
8. Tighten the two screw locks (21).
9. Reinstall the batteries (20), two cells for each side. Refer
NOTE: Unit does not operate if battery polarities are
reversed.
10. Replace the battery end plate (15) by turning the large
6.4
In troubleshooting the Vibrex 2000 and Vibrex 2000 Plus, be
aware that any problems generally fit into one or more of the
following categories:

Operator error

Equipment failure

Aircraft problem
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
window (on chassis, 01) line up, once they are inserted
into the chassis.
special attention to the ribbon cable and the shield (02),
if attached.
connector on the main PCB.
the four 4-40 screws (03). This plate only orients one
way and will not fit in place correctly any other way.
the four 4-40 screws (03).
to the picture inside the hand grips to determine battery
polarity. Also, see the diagram Section 6.3.7 Complete
Unit Disassembly and Section 6.3.1.5 "Reinstallation".
Phillips screw (16) clockwise with the Phillips
screwdriver.

Troubleshooting

Chapter 6 – Maintenance
13841 Rev A
235