If Unable To Use Weight Azimuth - Honeywell Vibrex 2000 User Manual

4. Press the
permanent weight radius, using the numeric keypad.
5. Press
The resulting solution displays the weight required at a single
balance point at the permanent radius.
5.4.4.1
The user may not be able to use the azimuth of the balance
weight, for clearance or other reasons, or the weight may be too
much for a single-weight addition point. In these cases, do the
following procedures:
1. Press the context key labeled AT [XX:XX].
2. Press the
3. Enter the angle or angles available for weight addition.
CAUTION: The user must enter two weight points one on
either side of the single-weight location in order for the
solution to result in the same IPS reading.
The Vibrex unit calculates the required weight on each point.
NOTE: As the weight is split farther apart, the required
weight becomes greater because of the lower combined
moment arm of the weight from the center of rotation.
4. Do a final run to verify that the user has installed the
permanent weights correctly. Then press
unit displays the following screen:
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
PERMANENT WEIGHT
when both values are correct.
START

If Unable To Use Weight Azimuth

SPLIT WEIGHT
Chapter 5 – General Operation
context key and enter the
context key.
13841 Rev A
123
. The Vibrex
DONE