Cleaning - Honeywell Vibrex 2000 User Manual

Chapter 6 – Maintenance

Using a longer, self-tapping 4-40 screw
6.3.4
This section explains basic housekeeping-type operations the
user needs to perform with the Vibrex unit.
Before cleaning, disassemble the unit in the same way as the user
would for EPROM replacement (see Section 6.3.2.3
"Replacement Procedures").
Finishing Up -
1. Using a moist cloth and mild detergent, clean the face of
2. Blow out any dirt in the interior of the chassis.
3. Ensure the unit is dry before reassembly.
6.3.5
We recommend that the user perform a yearly function test end
to end, on the Vibrex 2000 and Vibrex 2000 Plus. If the readings
obtained during this test are within the unit's specifications for
that reading in frequency, amplitude, and phase, then the unit is
operating correctly. If not, then the unit may need servicing.
6.3.5.1
The Model 11 Calibrator may be used to perform an end to end
check of the Balancers system as follows.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.

Cleaning

Finish the cleaning operation, as follows:
the instrument. To add more protection to the
instrument, the user may apply a light film of Armor All
to the control subpanel.
Testing
System Testing Using Model 11
Calibrator
13841 Rev A
216