Removal - Honeywell Vibrex 2000 User Manual

Chapter 6 – Maintenance
6.3.1.4
Remove batteries from the Vibrex unit, as follows:
1. Using a Phillips screwdriver, turn the large Phillips
2. Carefully remove the battery end plate.
3. Hold the unit with its connector subpanel pointing
4. Slide the batteries out of the side hand grips.
NOTE: The user may find out whether batteries are low on
power by using the Status feature. To access, press the
STATUS
6.3.1.5
When replacing the batteries it is important to observe the proper
orientation as depicted by the decals located inside the Vibrex
2000 battery tubes. Reinstall the batteries, as follows:
1. Insert the right-side batteries (in the hand grip next to the
1. 2. Install the left-side batteries (in the hand grip next to
2. Reinstall the battery end plate (15) in the reverse order
3. For an illustration, see the diagram in Section 6.3.1.3
NOTE: Failure to properly install the batteries could result
in a battery leaching its electrolyte onto the electronic
circuitry inside the Vibrex 2000, destroying the circuit
board. This is especially true if only one battery is reversed.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.

Removal

screw on the unit's battery end plate (15), one quarter
turn counter-clockwise.
upward.
button from the Main Menu screen.
Reinstallation
contrast buttons) negative end first. The raised contact
must be facing out.
the context keys) positive end first.
of removal.
Battery Insertion Diagram. Diagrams on the inside of the
hand grips illustrate the correct battery insertion and
polarity.
13841 Rev A
210