Honeywell Vibrex 2000 User Manual page 65

<PEAK LIST>
<ORDER LIST>
<RAW FFT>
Printing Status Information and Fault Log -
may print Vibrex unit status information, as follows:
1. From the Main Menu screen, press
Vibrex unit to complete its battery voltage and sensor power
tests. The Vibrex 2000 gives the user its test results by
showing the battery voltage and an OK or the FAIL
message for sensor power.
2. Make sure to set up the printer then press
The resulting printout shows the status of the Vibrex 2000 or
Vibrex 2000 Plus and includes a fault log. If the unit cannot
operate or if there is an error in operation, the Vibrex unit makes
an appropriate entry in the fault log. For help in interpreting the
fault log, contact Honeywell Customer Support.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
NOTE: It is not advisable to print the
using a thermal printer. Use this feature primarily for
PCs with their own software programs that generate
graphic spectra.
Chapter 3 – Getting Started
memory.
Prints the 10 highest peaks for a
spectrum with the information block
for the acquisition.
Prints the order list of half through
12 orders in half increments, if an
th
azimuth signal was present with the
information block for the acquisition.
Prints the vibration energy in each of
the 400 bins of the FFT with the
information block for the acquisition.
STATUS
13841 Rev A
49
data,
RAW FFT
The user
. Allow the
.
PRINT