Assembly - Honeywell Vibrex 2000 User Manual

Chapter 6 – Maintenance
1. Observe the antistatic procedures explained under
2. Make sure the unit is turned off.
3. Remove the battery end plate (15) by turning the large
4. Remove the batteries (20).
5. Remove the four 4-40 screws (03) from the shield (02)
6. Reach in with two fingers and disconnect the ribbon
7. Remove the four 4-40 screws (03) from the connector
8. Remove the main PCB from the chassis by pulling on
6.3.7.3
Reassemble the Vibrex unit, as follows:
1. Observe the antistatic proce
2. Partially loosen the two screw locks (21) on the nine-pin
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
Section 6.3.2 "EPROM Replacement".
Phillips screw (16) counter-clockwise with the Phillips
screwdriver.
with a Phillips-head screwdriver.
cable (for the keyboard) from the main PCB (14). Be
careful not to damage or kink the connector ribbons.
end plate (04).
the connector end plate slowly. Pay special attention to
feeding the shield (02) through the chassis (01), since it
is attached to the main PCB (18).
Alternately, the user can detach the shield from the main
PCB by removing the 4-40 nut (22).

Assembly

Section 6.3.2 "EPROM Replacement".
connector. These parts hold the main PCB (14) to the
connector end plate (04). Loosening these parts allows
the main PCB to "float" as it is inserted into the chassis
(01).
ures explained under
d
13841 Rev A
234