Table of Contents
Advertisement
Chapter 5 – General Operation
point 1.0 in. per sec (IPS) displays under the SET
SENSITIVITY line. This distance is equivalent to the distance
between 0 IPS and the 1.0 IPS ring on a polar chart. Note that, as
the horsepower reading changes, the weight value goes up as
well.
The weight sensitivities are set for weight installed on the
spinner mounting screws. If a location closer to the center of
rotation is chosen, consider using a higher horsepower setting to
increase the weight used.
5.4.1.4
Sensitivity refers to the response of the propeller to weight
changes in
The amount of weight per IPS move line
The angular performance when weight is added to the blade
with the reflective target
Enter this information, using the Set Sensitivity screen. Access
this screen by pressing the
the second Propeller Balance Setup screen.
The illustration below gives an example of the Set Sensitivity
screen.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
Setting Sensitivity
SET SENSITIVITY
13841 Rev A
context key from
104
Advertisement
Chapters
Table of Contents
