Selecting Channels - Honeywell Vibrex 2000 User Manual

Chapter 5 – General Operation
The Edit Aircraft ID screen displays (see below).
= EDIT AIRCRAFT ID ==
► CURSOR LEFT
► CURSOR RIGHT
► RESTORE/RESET FIELD
2. From this screen, select the places to be filled by pressing the
CURSOR LEFT
illustration under step 1).
NOTE: When the user is printing, the aircraft ID entry for the
current aircraft prints out on the hard copy. This ID also labels
data when the user is reviewing propeller balance
measurements.
3. If the user makes a mistake, press the
context key to start over.
4. After the user has entered the aircraft ID, press
(dedicated key) to return to the first Propeller Balance Setup
screen.
5. The user may press
action also returns the user to the previous screen.
5.4.1.2
The Vibrex unit defaults to the following channel assignments:
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
[
if ok, push START
or
CURSOR RIGHT
GO BACK

Selecting Channels

]ENG-[1]
context key (see the
RESTORE/RESET FIELD
to cancel or undo any edits. This
13841 Rev A
100
CURSOR
ENTER THE
AIRCRAFT ID
NUMBER
HERE; THE
DEFAULT IS 1
START