Main Rotor Track (Fastrak®) (Ev2K+ Heli Only) - Honeywell Vibrex 2000 User Manual

Chapter 5 – General Operation

If
Strobex in paragraph 5.5.1.2, "Main Rotor Track (Strobex)
(EV2K+)".

If FasTrak is selected, proceed to the next section.
5.5.1.3
The EV2K+ Heli is pre-programmed with many helicopter main
rotor track configurations that match the helicopter balance
models. The list can be found in Appendix C. Do main rotor
FasTrak
1. Install a single interrupter on the rotating swashplate, in the
same way as the user would for any track-and-balance
operation.
NOTE: If the aircraft installation normally uses a double
interrupter with the other single interrupters, remove the
double interrupter and other single interrupters so there is
only one single interrupter on the rotating swashplate.
2. Mount the magnetic pickup, in the same way as the user
would normally.
3. Connect the magnetic pickup cable to the channel A
connector of the Vibrex unit.
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
► < A - 1 0 9 E G n d F a c t o r y >
► S T R O B E X
T r a c k i n g 4 B l a d e s
► F a s T r a k
► C H A N G E T R A C K C O N F I G
is selected, proceed the same as V2K/V2K+
STROBEX
Main Rotor Track (FasTrak®) (EV2K+
Heli Only)
®
track operations as follows:
13841 Rev A
136