Test Feeding - Ricoh L5160 Cip Training

CIP Training L5160/L5130
Basic Operation
5. Press [Close].
• Operate the machine in an environment that is within 15–30°C (59–86°F). The
heater temperature may not reach the setting value due to the surrounding
temperature conditions.
• When you turn the heater temperature down, change the job settings for the RIP
software to the following to ensure enough time for drying. For details about the
settings, see "Changing Printer Settings", RIP Settings Guide.
• Increase the drying time.
• Select a print mode with a higher number of passes.
• Print unidirectionally.
• The temperature of heaters can also be set in the RIP software. When the
temperature settings for the heaters are sent from the RIP software, the settings
configured in the RIP software take priority over the settings configured on the
control panel of the machine. For details, see "Changing Printer Settings", RIP
Settings Guide.
• Setting the heater temperature too high may lead to temperatures outside the
operating range of the machine. Avoid setting the heater temperature too high.

Test Feeding

Perform test feeding to check whether the temperature settings of each heater are appropriate
for the media to be used.
1. Press the [Standard Procedure] key.
2. Press [ ].
3. Press [Test Feed].
4. Press [Yes] when you rewind the media to its original position after performing test
feeding.
DWU103