How to Set Parameters in the Product
There are two methods to set a parameter in the Product.
You can set a parameter from a list of values or in the
case of numerical values, set a parameter with the cursor
keys.
Value List
An example where you select from a list of values is the
preset selection.
1. From the main screen, push .
2. Push the softkey below SELECT PRESET in the
display.
As shown in Figure 17, the number 1 is highlighted to
the right of PRESET:.
Figure 17. Preset Selection
3. To change the preset number, push and to scroll
through the preset numbers.
4. Push when the correct preset number is shown
in the display.
This is the selection method for value lists.
Set Number Value
An example where you set a number is where you set the
setpoint temperature.
1. From the main screen, push .
2. Push .
As shown in Figure 18 the left most digit in the
SETPOINT temperature is highlighted.
SELECT
PRESET
gxs111.eps
Figure 18. SETPOINT Temperature
Calibration Furnace
Operation
SAVE/
DISABLE
gxs110.eps
25