Fluke 9118A User Manual page 63

Parameters: n =
Example:
SYST:BEEP 1
SYSTem:BEEP:KEYB?
Gets the state of the keyboard beep function.
Example:
SYST:BEEP?
Response: 0
SYSTem:CODE:VERS?
Gets the version of the firmware.
Example:
SYST:CODE:VERS?
Response: 1.10
SYSTem:COMM:SER:BAUD [baud]
Sets the baud rate of the serial interface.
Parameters: baud =
Example:
SYST:COMM:BAUD 2400
SYSTem:COMM:SER:BAUD?
Gets the baud rate of the serial interface.
Example:
SYST:COMM:BAUD?
Response: 1200
SYSTem:COMM:SER:LIN [n]
Sets the use of a line feed character at the end of data sent out the serial interface.
ON or 1 Turn on keyboard beep. (Default)
OFF or 0 Turn off keyboard beep.
Turn on keyboard beep.
keyboard beep is off. (1 = on)
The version of firmware is 1.10.
1200, 2400, 4800, 9600, 19200, 38400 (Default = 2400)
Sets the baud rate of the serial interface to 2400.
The baud rate of the serial interface is set to 1200.
Calibration Furnace
Alphabetic List of Commands
53