Table of Contents
Advertisement
PROGram:SEQ:PAR? <Par>
Get a parameter from the ramp/soak test.
Parameters:
Par
=
Example:
PROG:SEQ:PAR? SPO2
PROGram:STATus <n>
Sets the execution state for the selected program.
Parameters:
n
=
Example:
PROG:STAT 1
PROGram:STATus?
Sets or gets the execution state for the selected program.
Example:
PROG:STAT?
Response: 0
x = 1 to 8 setpoint number. Default = 1. Gets setpoint temperature for the setpoint
SPO[x]
number.
Gets soak time
DWEL
Gets the number of setpoints in the ramp/soak test.
POIN
Gets the number of times the ramp/soak test is to be repeated.
CYCL
Gets the direction of how the setpoints will be done in the test. See DIRECTION in the
DIR
Ramp/Soak Menu section.
Gets the setpoint temperature for setpoint number 2.
RUN or 1
Start the selected program.
OFF or 0
Stop the selected program. (Default)
Starts the selected program.
The selected program is stopped.
Calibration Furnace
Alphabetic List of Commands
45
Advertisement
Table of Contents
