Fluke 9118A User Manual page 13

•
Applicable personal protective equipment
must be worn when you move hot temperature
probes or do work near the furnace apertures.
•
Do not use the Product for applications other
than calibration work.
•
The Product must only be used by approved
personnel.
•
Do not touch surfaces near the well access
port. They can be very hot.
•
Do not touch the insulation material in the
Product. The insulation material can cause
mild mechanical irritation with skin, eyes, and
upper respiratory system. If it gets on your
skin, flush area and wash gently. Do not rub or
scratch exposed skin. If it gets into your eyes,
flush abundantly with water. Do not rub eyes. If
the nose and throat become irritated, move to
a dust-free area and blow nose. If symptoms
continue, get medical advice.
 Caution
To prevent damage to the Product:
•
Operate the Product at room temperature.
See specifications.
•
Keep a minimum of 45 cm clearance from
the front, left, and right sides. Keep 150 cm
from the top of the Product.
•
Do not put the Product in a corner or cause
a blockage behind the Product.
•
Do not use fluids to clean out the well.
Fluids in the Product can cause damage.
•
Do not put unwanted material into the
probe protection tube or hole of the insert.
Fluids in the Product can cause damage.
•
Only change calibration constant values
from the factory set values when you
calibrate the Product. These values are
important in the safe operation of the
Product.
•
Read and understand the operation before
you turn on the Product.
•
Do not operate the Product in wet, oily,
dusty, or dirty environments.
•
Make sure the probe handle temperature
does not go above its limit.
Calibration Furnace
Safety Information
3