Set the Furnace Temperature Manually
To adjust the furnace temperature manually:
1. Push .
2. Push .
3. Push to increase the temperature or push to
decrease the setpoint temperature.
When you push the up or down key momentarily,
the setpoint temperature moves by one step. Push
and hold the key and the setpoint temperature
increases or decreases until the key is released.
4. Push to save the setpoint temperature and start
the furnace.
After a maximum of 5 seconds, the furnace starts
to heat or cool to the setpoint temperature.
The actual temperature is the measured temperature in
the furnace and lags the setpoint temperature. The lag
interval is the time necessary to increase or decrease the
temperature of the center of the furnace.
How to Stop the Furnace Heat Cycle
To stop the furnace heat cycle:
1. With the main screen in the display, push .
2. Push the softkey below SAVE/DISABLE.
The heat or cool procedure stops and the Product is set to
standby mode.
Note
Note
Change a Preset Temperature
You can set the temperature of the eight presets. To
change a preset temperature:
1. Push .
2. Push the softkey below SELECT PRESET.
3. Push or to scroll to the preset to change.
4. Push the softkey below EDIT PRESET. As shown in
Figure 22 the temperature of the selected preset is
highlighted in the display.
Figure 22. Change Preset Temperature
Calibration Furnace
Operation
gxs112.eps
33