How To Configure The Digital Interface; Input Terminators; Scpi Commands; Commands By Function Or Group - Fluke 9118A User Manual

How to Configure the Digital Interface

To control the Product with a PC, you must set the
parameters of the digital interface in the Product. To set
the interface parameters:
1. Push .
2. Push the softkey below SYSTEM MENU.
3. Push the softkey below COMM SETUP.
4. Set the RS-232 parameters to the values as the
parameter values for the PC interface.

Input Terminators

An input terminator is a character sent by the PC that
identifies the end of a string. When the Product receives
an input terminator, it does the command preceding the
terminator character.
Applicable terminators are:
•
LF (Line Feed)
•
CR (Carriage Return)
•
CR LF (Carriage Return/Line Feed)
In some instances, a terminator is automatically sent at the
end of an output string from the PC.

SCPI Commands

This section gives all SCPI commands recognized by the
Product with their description and syntax rules.

Commands by Function or Group

Table 5 is a list of commands grouped by Calibration, Main
Screen, Program, Setup, System, and Temperature.
Calibration Furnace
Remote Operation
37