9118A
Users Manual
When the self test is complete and no errors are sensed,
the screen shown in Figure 16 shows in the display. The
Product is in a standby mode. You must set a setpoint
temperature to start control of the furnace. See the "Adjust
Furnace Temperature" section to learn how to start the
temperature control of the furnace.
Figure 16. Main Screen
22
How to Turn Off the Product
To avoid personal injury, do not disconnect
the product from mains power if the furnace
temperature is greater than 80 °C.
To prevent possible damage to the Product,
disable the temperature control first and then
turn off power.
To turn off the Product:
1. Push .
2. Push the softkey under SAVE/DISABLE to disable the
heaters.
3. Push the "O" side of the power switch, on the front
qxs002.bmp
panel of the Product.
Warning
Caution