Table of Contents
Advertisement
9118A
Users Manual
Protection Tube and Support Bracket
Installation (and Optional Isothermal Block)
Warning
To prevent personal injury, disconnect the
Product from mains power and when
applicable, allow to cool to 80 °C prior to
performing any maintenance or installation
work on the Product.
To install two protection tubes and a thermocouple (TC)
support bracket and optional isothermal block (9118A-
ITB):
1. Remove the five socket-head screws and take down
the rear shield from unit. See Figure 6.
14
Rear Shield
Socket
Head Screw
Figure 6. Rear View of 9118A Thermocouple
Calibration Furnace with Isothermal Block
gxs124.eps
Advertisement
Table of Contents
