Table of Contents
Advertisement
This command has password protection. Use the SYST:PASS:CEN command first before you use this command to
set this value.
Parameters:
n
=
DEF
Example:
SYST:PASS:NEW 1045
This command has no response.
SYSTem:PASS:PROT <n>
Sets the password protection level.
Parameters:
n
=
Example:
SYST:PASS:PROT 1
SYST:PASS:PROT?
Gets the password protection level.
Example:
SYST:PASS:PROT?
Response: 0
0000 to 9999
Sets the password to 1234.
Sets the password to 1045.
0 – Low
1 – High
Sets the password protection level to high.
The password protection level is low.
Note
Calibration Furnace
Alphabetic List of Commands
57
Advertisement
Table of Contents
