Install A Rtm Isdn Card - Polycom RealPresence RMX 4000 Hardware Manual

▪ Partially Open-The ejector levers are partially open and the blue HS LEDs on the card and the
Control Unit are flashing. When the blue LEDs are constantly lit the card is in a powered-down
mode and can be safely removed.
▪ Fully Open-The ejector levers are in the fully open position. In this position the card is released from
the MCU housing and can be removed.
To open and close the ejector levers:
Procedure
▪ Unlocking the Lock Catch-With your thumb on the handle (2) and your index finger on the lock
catch (1), pinch thumb and finger together while lifting the handle away from the chassis.
Caution:
▪ Closing the Lever-With your thumb on the handle (2) and press the lever against the panel until it
clicks into place.

Install a RTM ISDN card

To install a RTM ISDN card:
Procedure
1. On the RTM ISDN card move the ejector levers to their fully open position.
2. Slide the new RTM ISDN card into its slot.
Polycom, Inc.
Initiated process cannot be terminated
Once the removal sequence is initiated the process cannot be terminated
and the HS led flashes when activated.
RMX 4000 Installation
22