Table of Contents
Advertisement
Installing the RTM ISDN Card on the RealPresence Collaboration Server
(RMX) 4000
The ISDN card is shipped out of the box and must be manually installed into the rear of the
RMX 4000. It is recommended that the ISDN card be installed before the RMX 4000 is
installed in a rack. For more information on installing the ISDN card, see "Installing or
Replacing the RTM ISDN Card" on page 2-10.
An RMX Software License is included with the ISDN card and must be registered as part of
the Product Registration and Product Activation. For more information, refer to the ISDN
Software Licence document you received with your shipment.
Installing the RMX in a Rack or as a Standalone
Either place the RMX 4000 on a hard, flat surface such as a desktop or mount it on a 19"/23"
rack or a rack with telescopic rail runners.
Standalone RealPresence Collaboration Server (RMX) 4000 Installation
>> Place the RMX 4000 on a flat surface or desktop.
Rack Mount Preparations
•
•
Polycom, Inc.
The RMX 4000 must rest on the four feet at the base of the MCU and must be shifted or
moved into position using the two handles attached to the front.
Optional - Depending on the rack installed in your site, you may need to remove the
handles if they are attached to the RMX 4000. Unscrew the handles from the chassis as
shown in Figure 1-1, "Optional - Feet and handle removal".
Optional - If the opening in the rack that is allocated to the RMX 4000 is exactly 6U, the
feet must be removed from the RMX 4000 to install it in the rack. Unscrew the feet from
the chassis as shown in Figure 1-1, "Optional - Feet and handle removal".
Figure 1-1
Optional - Feet and handle removal
Chapter 1-Hardware Description
1-9
Advertisement
Table of Contents
