Rtm Lan Card; Rtm Lan Card-4 Lan Ports - Polycom RealPresence RMX 4000 Hardware Manual

Procedure
1. On the RTM ISDN card move the ejector levers to their fully open position.
2. Slide the new RTM ISDN card into its slot.
3. Push the card into the slot until the ejector levers touch the front edge of the card cage.
4. Push the ejector levers to their fully closed position.
5. Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN
card to the MCU.
When a new ISDN card is installed you are required to do the followings:
▪ Update your license.
For more information, see the RealPresence Collaboration Server (RMX) 1800/2000/4000/Virtual
Edition Getting Started Guide, First Entry Power-up and Configuration.
▪ In the ISDN Network Services, define a New ISDN Network Service.
For more information, see the RealPresence Collaboration Server (RMX) 1800/2000/4000/Virtual
Edition Administrator Guide, Adding/Modifying ISDN Network Services.

RTM LAN Card

Two RTM LAN cards are available: RTM LAN Card with 4 LAN Ports and RTM LAN Card with 2 LAN
Ports.
Related Links
Pin Assignment of Ports on the RTM LAN Card

RTM LAN Card-4 LAN ports

The RTM LAN card routes data between the MPMRx cards and components of the system, and sends
media by IP packets and provides connectivity to external IP networks.
RTM LAN card-4 LAN ports
Picture below shows the RTM LAN card-4 LAN ports rear panel layout.
Polycom, Inc.
RealPresence Collaboration Server (RMX) 4000 Rear Panel
on page 60
52