Install Or Replace The Rtm Isdn Card - Polycom RealPresence RMX 4000 Hardware Manual

Collaboration server

Hide thumbs Also See for RealPresence RMX 4000:

Table of Contents

RealPresence Collaboration Server (RMX) 4000 Components and Components Replacement

Install or Replace the RTM ISDN Card

Carry out the following procedures to remove a RTM LAN or existing ISDN card, or install a new or

replacement RTM ISDN card on the RMX 4000.

To remove an RTM LAN or existing ISDN card:

1 Ensure that the power switch on the RMX 4000 is turned OFF (O).

2 Remove the RTM LAN or RTM ISDN card by unscrewing the captive screws that fasten the card to

the RMX. When removing a card, use the metal ejector levers to pull the RTM LAN or RTM ISDN

card out of its slot from the backplane.

3 Slide out the RTM LAN or RTM ISDN card.

To install a new or replacement RTM ISDN card:

1 On the RTM ISDN card move the ejector levers to their fully open position.

2 Slide the new RTM ISDN card into its slot.

Note: RTM ISDN card and MPMx/MPMRx card

An RTM ISDN card must connect directly to an MPMx/MPMRx card in the opposite facing front slot.

3 Push the card into the slot until the ejector levers touch the front edge of the card cage. Push the

ejector levers to their fully closed position.

4 Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN card

to the MCU.

Polycom, Inc.

Table of Contents

Do you have a question about the RealPresence RMX 4000 and is the answer not in the manual?