Polycom RealPresence RMX 4000 Hardware Manual page 3

Regulatory Notices
Warning:
Environmental
This product is compliant with the requirements of the recast RoHS Directive 2011/65/EU. Information can
be obtained from Polycom Ltd, 270 Bath Road, Slough, Berkshire, SL1 4DX, UK or via:
RoHSinformation@polycom.com
Information on recycling can be found at:
Disposal of this equipment should be carried out in accordance with local environmental guidelines and
regulations for waste. For further information please contact:
Batteries
Below is a listing of batteries that could be present in the product:
Description:Internal CMOS battery
Type:CR2032 Lithium Coin Cell
Weight:3.3g
Batteries used in this product are in compliance with EU Battery Directive 2006/66/EC.
Batteries in this product are not based on mercury, lead or cadmium technologies.
Batteries in this product are not intended to be replaced or removed by the user
Additional information on the safe use and recycling of batteries can be found at:
batteries
United States Federal Communication Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Regulatory Notices
No user-serviceable parts inside. Do not open.
The plug-socket combination must be accessible at all times, because it serves
as the main disconnecting device.
This equipment must be earthed. Do not power this equipment if the integrity of
themains earthing conductor cannot be verified.
Only trained and qualified personnel should be allowed to install, replace,
service or repair this equipment
To prevent system overheating do not operate in an ambient temperature
exceeding 40° C / 104° F
Installation of this equipment must comply with local and national electrical
codes.
www.polycom.com/WEEE
TakeBack@polycom.com
www.polycom.com/