SMA Sunny Island 2012 Technical Description page 79

SMA Solar Technology AG
Overview of System Configurations:
The system configuration is described extensively in chapter 7.7 "Configuring a System with Several
Sunny Islands" (Page 68).
Displayed Text
1phase 1SI
1phase 2SI
1phase 3SI
Three 3SI
8. After entering the parameters, the following
message appears on the display:
"Init Device OK
START?"
9. Confirm the question:
Press and hold the pushbutton on the Sunny
Remote Control 1.
10. The following message appears:
„ST(A)NDBY: To Start INV(erter) hold <Enter>"
The QCG is complete.
To start the Sunny Island:
11. Press and hold the pushbutton on the Sunny
Remote Control 1.
During this procedure a bar appears on the
display.
12. When the bar on the display disappears and the
Sunny Remote control emits a tone signal:
Let go of the Sunny Remote Control pushbutton.
13. The Sunny Island starts.
The Sunny Island is in operation.
2)
These applications are only possible with firmware versions 3.0 and above.
Technical Description
2)
Meaning
single-phase system, 1 Sunny Island
single-phase system, 2 Sunny Islands
single-phase system, 3 Sunny Islands
3-phase system, 3 Sunny Islands
Init Device OK
START?
STNDBY: To Start
INV hold <Enter>
SI2012_2224-TEN082311
(First) Commissioning
79