SMA Sunny Island 2012 Technical Description page 115

SMA Solar Technology AG
Please note:
• Do not switch off the device during the firmware update!
• Do not remove the MMC/SD card during the firmware update!
• Observe notices regarding the update files.
Updating the Firmware
1. Set the Sunny Island to standby.
2. Insert the MMC/SD card in the Sunny Remote
Control 1's card slot.
3. The messages below are displayed while the
Sunny Island does the update:
After the Update
• After the update has been successfully completed a reset is enforced in order for
the changes to become effective.
• Please Note
4. After the reset, the Sunny Island remains in
standby mode.
5. Start the device manually (see chapter 10.1.1
"Switching On/Starting" (Page 83)).
Technical Description
Operating the Sunny Island
Update 1/2
[¿¿¿¿¿¿ ]
Update 2/2
[¿¿¿¿¿¿ ]
SI2012_2224-TEN082311 115