Wall Mounting - SMA Sunny Island 2012 Technical Description

Installation

5.3.3 Wall Mounting

Mount the Sunny Remote Control 1 on the wall. Proceed as follows:
1. Allow enough room for installing a communications cable and a MMC/SD card.
2. Determine the position of the two holes to be drilled using the Sunny Remote Control's
mounting plate.
To do this, unscrew and remove the mounting plate from the back of the Sunny Remote
Control.
3. Draw the position of the holes to be drilled.
4. Install the dowels and screws included.
5. Install the dowels and screws included
Allow for the heads of the screws to
protrude about 6 mm from the surface of
the wall.
6. Screw the mounting plate onto the Sunny
Remote Control enclosure.
7. Hang the Sunny Remote Control onto the
screws.
8. Check to see it sits correctly.
32 SI2012_2224-TEN082311
SMA Solar Technology AG
Technical Description