Chrysler Pacifica 2004 Service Manual page 842

Hide thumbs Also See for Pacifica 2004:

Table of Contents

LEFT HEADLAMP HIGH BEAM OPEN-IPM —

Turn the ignition off.

Disconnect the Left Headlamp harness connector.

Using a 12-volt test light connected to ground, check the Left High Beam Driver

circuit in the Left Headlamp harness connector.

NOTE: The test light must illuminate brightly. Compare the brightness to

that of a direct connection to the battery.

Turn the High Beam headlamps on.

Does the test light illuminate brightly?

Yes → Replace the Left High Beam Headlamp Bulb.

→ Replace the Integrated Power Module.

Turn the ignition off.

NOTE: Visually inspect the related wiring harness and circuits. Look for

any chafed, pierced, pinched, or partially broken wires.

NOTE: Visually inspect the related wiring harness connectors. Look for

broken, bent, pushed out, or corroded terminals.

NOTE: Refer to any Technical Service Bulletins (TSB) that may apply.

Were any problems found?

Yes → Repair as necessary.

→ Test Complete.

Perform BODY VERIFICATION TEST - VER 1.

EXTERIOR LIGHTING

APPLICABILITY